*FIRMWARE_REVISION=93
*BUILD_DATE_TIME=Nov 22 2016 00:14:11
*OSCCAL=131			# Oscillator Calibration, refer to manual section "Micro-controller Oscillator Calibration for UART speed adjustment"
DATE=10				Time on UPS, day of month
MONTH=2				Time on UPS, Month
YEAR=2018			Time on UPS, Year
HOUR=20				Time on UPS, Hour
MIN=35				Time on UPS, Minute
SEC=28				Time on UPS, Seconds
DAYOFWEEK=7			Current day of the week. Range 1-7, 1 = SUNDAY
*UPTIME_SEC=50905		UPS uptime in seconds
SETTINGS_TC_SEC=235331		Refer to manual section "Time Correction Settings – Watch Crystal Adjustment"
SETTINGS_TC_SEC_POS=0		''	''
SETTINGS_DLS_x			Refer to manual section "Time and Date – Daylight Savings Time"
*MAIN_POWER=1			5v power status, 1=power on
*UPS_POWER=1			UPS power status, When power has failed and battery is low variable is set to 0
POWER_COMMAND=0			UPS requested commands to OS, 2=reboot, 3=shutdown
TIMED_SHUTDOWN=0		Seconds to power cut by UPS, used during shutdown of OS to request a power cut
*MAIN_POWER_REQUESTED=1		Indicates the state of power *requested* by the user, an input or timer variable. 1=request power on
*ADC_VIN_VOLTS=15.00		Input voltage
*ADC_VBATT_VOLTS=13.07		Battery input voltage
*ADC_VINVBATT_VOLTS_DIFF=1.93		Voltage difference Input/battery
SETTINGS_WATCHDOGTIMER_ENABLE=0		Watchdog timer status, 1=enabled, see manual
SETTINGS_WATCHDOGTIMER=300		Watchdog countdown timer setting, see manual
SETTINGS_WATCHDOGTIMER_OFFTIME=10	Watchdog off time counter setting, see manual
*WATCHDOGTIMER=300			Watchdog countdown timer, see manual
*WATCHDOGTIMER_OFFTIME=10		Watchdog off time counter, see manual
SETTINGS_UPS_POWER_FAIL_VOLTS=9.00	Input voltage threshold for a power failure
SETTINGS_UPS_BATT_SHUTDOWN_VOLTS=7.10	Battery voltage threshold for system shutdown
SETTINGS_UPS_BATT_POWERUP_VOLTS=7.50	Battery voltage threshold for system powerup
SETTINGS_UPS_V_OR=0			See vmopower-ups-firmware-v0.92-build-05-23-2016-203202-release-notes.txt
LED_STAT=0				Controls status LED
*ADC_x					See ADC notes on webpage under FAQs.
*PIN_SWITCH2=1				Secondary switch status, 0=switch depressed
*PIN_x					Digital status of corresponding P2 pins
OUT_x					Digital output setting of corresponding P2 pins
PORT_x					PORT setting of corresponding P2 pins
DD_x					Data direction register setting of corresponding P2 pins
INPUT_CONTROL[x]			see manual
TIMER_CONTROL[x]			see manual
MORSE					MORSE CODE sent to AMBER stat LED
MORSE_SPEED				Lenght of DOT in 1/16 sec
MORSE_PWROFF				controls if the morse 'blink' is send when the Pi is powered off, 0 for No (default), 1 for yes